Emergi-Lite FPDL-32 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Освітлювальне обладнання Emergi-Lite FPDL-32. Emergi-Lite FPDL-32 5 сторінок.

Друкувати сторінку

5. BALLAST WIRING BLOCK DIAGRAM

Illustration 3

HOT A.C. LINE

COMMON

TBTS

6. LABELS

Attach the appropriate labels adjacent to the

Caution and the Re-lamping labels must be on the fixture in a readily visible location to anyone attempting to

service the fixture.

7. COMPLETING INSTALLATION

When the installation is complete, switch the A.C. power on and join the

Normal Mode - A.C. power is present. The A.C. ballast operates the fluorescent lamp(s) as intended. The

standby charging mode. The

Emergency Mode - The A.C. Power fails. The

Emergency Mode

. One lamp is illuminated, at reduced output, for a minimum of 90 minutes. When the A.C. Power is

FPDL-32

restored, the

switches the system back to the

Instruction Manual.

Pressing the red lens on the

mode. This interrupts power to the emergency lamps only. The emergency lamp is now being lit by the

bright than the other lamps in the system. To simulate a BLACK OUT use the or circuit breaker to turn off A.C. Power.

Initial Testing - Allow the unit to charge approximately 1 hour, then press the

Allow a 24 hour charge before conducting 90 minute test.

FPDL-32

The

is a maintenance free unit, however, periodic inspection and testing is required. NFPA 101, Life Safety Code,

outlines the following schedule:

Monthly - Insure that the

. One lamp should operate at reduced output.

Annually - Insure that the

intended for the duration of the test.

"Written records of testing shall be kept by the owner for inspection by the authority having jurisdiction."

SERVICING SHOULD BE PERFORMED BY QUALIFIED PERSONNEL.

Switched Fixture

BLACK

A.C. BALLAST

WHITE

WHT/BLK

WHITE

(277V) ORG

FPDL-32

(120V) BLK

WHT

WHT/RED

+ RED

Select proper voltage lead. Cap unused lead.

OPERATION

TBTS

will be lit providing a visual indication that the battery is being charged.

FPDL-32

TESTING & MAINTENANCE

TBTS

turns off the light on the

TBTS

is illuminated. Conduct a 30 second discharge test by depressing the

TBTS

is illuminated. Conduct a full 1 1 /2 hour discharge test. The unit should operate as

HOT A.C. LINE

COMMON

TBTS

. Annotate Re-lamping label for lamp type and wattage. The

senses the A.C. Power failure and automatically switches to the

Normal Mode

and resumes battery charging. See page 1 of the

TBTS

and forces the unit into emergency

Page 3

Unswitched Fixture

BLACK

WHITE

WHT/BLK

WHITE

(277V) ORG

(120V) BLK

WHT

WHT/RED

+ RED

Select proper voltage lead. Cap unused lead.

FPDL-32

unit connector.

FPDL-32

TBTS

to conduct a short discharge test.

TBTS

A.C. BALLAST

FPDL-32

is in the

unit and will be less