HiBoost Mini F08GI-5S-BTW Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Подовжувач HiBoost Mini F08GI-5S-BTW. HiBoost Mini F08GI-5S-BTW 14 сторінок.

3.6 Install the Server (Indoor) antenna

If you use the built-in antenna ,please ignore this step .

Connect one end of the coaxial cable to the antenna and the other end to the cellular

booster where it is marked "Indoor".

Select the installation location of your supplied server (indoor) antenna based on the

following:

Omni directional antenna

Place in the center of the area where the signal needs to be amplified.

Panel directional antenna

Place in the outer perimeter of the area the signal needs to be amplified.

Install the cellular booster in a location that is properly ventilated and not exposed to

excessive heat, moisture and/or direct sunlight. The optimal area would be on a wall

located near a power outlet.

It should be mounted in an easily accessible area so it's easy to perform general

maintenance with the coaxial cable connections, dip switch settings and power

adaptor.

Make sure all cables and antennas are securely connected before commissioning the

system.

Once all the Following precautions have been taken, power on the cellular booster.

1. Verify that you have left at least 1 meter of vertical separation space between the

indoor and outdoor antennas.

2. Never point the front of the yagi donor (outdoor) antenna towards the inside of

the server (outdoor)antenna.

3. Verify that the supplied coaxial cables from both the donor (outdoor) antenna and

the server (outdoor)antenna are properly connected to the cellular booster before

powering it up.

4. Carefully plug in the supplied power adaptor into the back of the cellular booster

where it is marked 'DC 12V' and connect the other end to a power outlet.

The LED indicator marked power should light up green.

7 / 14