DaytonAudio HTA20 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач DaytonAudio HTA20. DaytonAudio HTA20 8 сторінок. 20w integrated stereo hybrid tube amplifier
Друкувати сторінку
Connections
Connecting Speakers
The amplifier can power speakers with a minimum impedance of 4Ω. Using high quality
two conductor speaker wire connect your speakers to the binding posts on the rear of
the unit.
Connect the HTA20's left speaker terminals marked "L-" and "L+" to the corresponding
"-" and "+" terminals on your left speaker. Repeat the same process for the right channel.
NOTE: Never connect the negative terminals together or to ground. The HTA20 is not
designed to operate in a bridged mode and attempting to do so may damage the amplifier.
Connecting Banana Plug Cables
1.
Tighten the knob.
2.
Insert the banana plug terminated cable into
the end of the corresponding terminal.
Connecting Speaker Wires
1.
Strip about 3/8" of insulation from the end of
each speaker wire and twist the bare wires of
the cable together.
2.
Unscrew the knob before inserting the bare
wire into the hole in the side of each terminal
before tightening the knob to secure the wire.
Connecting A Subwoofer
If you really want to feel the bass or just want to bother the neighbors you can add a
subwoofer using the S.W. OUT connection on the rear of the HTA20. This signal is
full range and will send a mono summed signal that is controllable by the front volume
knob. Using a single RCA cable you can connect to the line level input on a powered
subwoofer or to any external subwoofer amplifier to power passive subwoofers.
Connecting Headphones
Headphones can be connected to the ¼" TRS connection on the front of the HTA20.
This is great for listening to any source and enjoying the classic warmth from the tube
preamps. Plugging in headphones will stop any signal from being output to the speaker
output terminals or S.W. OUT.
NOTE: To avoid damage to headphones or your hearing make sure to turn down the
volume before plugging in your headphones. Always turn down the volume knob before
unplugging headphones to avoid accidental output to your speakers or startling any
cats napping nearby.
6