GAI-Tronics PA250-001 Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Підсилювач GAI-Tronics PA250-001. GAI-Tronics PA250-001 13 сторінок. 250 watt central amplifier

Model PA250-001 250 Watt Central Amplifier

600-ohm (balanced) and Tel-Page (balanced) Input

The 600-ohm balanced input and the Tel-Page balanced input (600-ohm) connections are made via screw

terminals on the rear audio input terminal block. Observe +/- polarity for proper signal phasing. Refer to

the Specification section for input sensitivity levels associated with the various inputs.

600-ohm/Tel-Page Audio Input Gain Control

This rear-mounted, recessed control allows adjustment of the 600-ohm/Tel-Page input level without

affecting the level of the Hi-Z inputs. This control works in conjunction with the master VOLUME

control located on the front panel. Both adjustments will have an effect on the output signal level from

these two input signals.

Dual Hi-Z inputs

The two H

-Z

(10-Kohm) are RCA-type female connectors that are paralleled internally. One

INPUTS

connection is for signal input, the other is for strapping to a second amplifier's input, if desired.

AUTO-MUTE for the Hi-Z Inputs

Audio signal applied to 600-ohm or Tel-Page input terminals will mute the two high impedance paralleled

inputs, unless defeated by the user. This mute feature is defeated by moving an internal jumper located

on the input PCBA, which is mounted on the back panel adjacent to the audio input terminal block

connections.

WARNING

Performing this AUTO-MUTE defeat modification requires the opening of the unit. This action should

be performed by qualified personnel only. Failure to follow instructions could result in damage to

equipment and/or injury to personnel.

Perform the following steps to move this jumper: Refer to Figure 2.

1. Unplug the ac power cord.

2. Remove the top cover assembly and locate the Input PCBA.

3. Find the header marked M

position.

4. Replace the top cover.

5. Reapply ac power.

Speaker Output Connections

The amplifier offers three different output connections to meet most system connection requirements.

Refer to Figure 4.

Direct 8-Ohm

Connect an 8-ohm speaker of proper power handling capability to the terminals marked 8-OHM

(BRIDGED). If adding more than one speaker, the resultant speaker line impedance should equal 8

ohms. Observe +/- polarity for proper signal phasing.

Note: This output is a BRIDGED output. DO NOT ground either of these terminals.

f:\standard ioms - current release\42004 instr. manuals\42004-340e.doc

06/02

. Move shorting plug from A (enable){factory default} to B (defeat)

UTE

Pub. 42004-340E

Page: 8 of 12