Automation Dr. Nix QNix 5500 Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Вимірювальні прилади Automation Dr. Nix QNix 5500. Automation Dr. Nix QNix 5500 20 сторінок.
Також для Automation Dr. Nix QNix 5500: Посібник із швидкого старту (12 сторінок), Посібник з експлуатації (16 сторінок)
Друкувати сторінку
5500
Section
Symbol
Description
Status bar
Calibration done
Battery level 100 % / 50 % / 25 % / empty
Note! When the batteries are below 50 %, a warning
screen will appear. Press "OK" to confirm the screen and
replace the batteries promptly.
Probe status bar
Probe connected
Measurement display n:
Total number of measurements
µm / mil
Unit for the coating thickness
n-1:
Last and next to last measurement
n-2:
NFe / Fe
Actual substrate
Analysis area
Average
x-max
Highest measurement
x-min
Lowest measurement
σ
Standard deviation
4.4 Measure
>
If necessary, start zero-adjustment.
>
Apply the probe and take a measurement.
Sensor ring colours
>
Green: measurement taken
>
Blue: measurement range exceeded
18
18 / 31
4 Operation and Controls
QNix 5500 EN_ES_FR_IT_NL_PL
5 Troubleshooting
5 Troubleshooting
If the device is not responding as expected, please check the following items:
Error
Possible Cause
Device doesn't switch on
Batteries drained
Calibration with reference plates
Incorrect reference plate selec-
produces implausible
ted
results
Device or probe defective
Sensor ring lights up blue
Measuring range exceeded
Sensor ring briefly lights up blue
No error
during probe change
(no error)
6 Service and Repair
The equipment must be repaired by our service partners or by a manufacturer authorised techni-
cian.
If you have any questions, please contact your local retailer or our Support:
www.q-nix.com/support
Automation Dr. Nix GmbH & Co KG
Robert-Perthel-Strasse 2
50739 Cologne
Germany
Tel.: +49 (0)221 91 74 55-0
Fax.: +49 (0)221 17 12 21
QNix 5500 EN_ES_FR_IT_NL_PL
5500
Action
Replace the batteries or connect
the device to a USB connection.
Select the reference plate
Fe/NFe based on your probe.
Please contact your authorised
service location.
Probe is connected correctly.
19 / 31
19