Automation Dr. Nix QNix 5500 Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Automation Dr. Nix QNix 5500. Automation Dr. Nix QNix 5500 20 stron.
Również dla Automation Dr. Nix QNix 5500: Skrócona instrukcja obsługi (12 strony), Instrukcja obsługi (16 strony)
Drukuj stronę
5500
Section
Symbol
Description
Status bar
Calibration done
Battery level 100 % / 50 % / 25 % / empty
Note! When the batteries are below 50 %, a warning
screen will appear. Press "OK" to confirm the screen and
replace the batteries promptly.
Probe status bar
Probe connected
Measurement display n:
Total number of measurements
µm / mil
Unit for the coating thickness
n-1:
Last and next to last measurement
n-2:
NFe / Fe
Actual substrate
Analysis area
Average
x-max
Highest measurement
x-min
Lowest measurement
σ
Standard deviation
4.4 Measure
>
If necessary, start zero-adjustment.
>
Apply the probe and take a measurement.
Sensor ring colours
>
Green: measurement taken
>
Blue: measurement range exceeded
18
18 / 31
4 Operation and Controls
QNix 5500 EN_ES_FR_IT_NL_PL
5 Troubleshooting
5 Troubleshooting
If the device is not responding as expected, please check the following items:
Error
Possible Cause
Device doesn't switch on
Batteries drained
Calibration with reference plates
Incorrect reference plate selec-
produces implausible
ted
results
Device or probe defective
Sensor ring lights up blue
Measuring range exceeded
Sensor ring briefly lights up blue
No error
during probe change
(no error)
6 Service and Repair
The equipment must be repaired by our service partners or by a manufacturer authorised techni-
cian.
If you have any questions, please contact your local retailer or our Support:
www.q-nix.com/support
Automation Dr. Nix GmbH & Co KG
Robert-Perthel-Strasse 2
50739 Cologne
Germany
Tel.: +49 (0)221 91 74 55-0
Fax.: +49 (0)221 17 12 21
QNix 5500 EN_ES_FR_IT_NL_PL
5500
Action
Replace the batteries or connect
the device to a USB connection.
Select the reference plate
Fe/NFe based on your probe.
Please contact your authorised
service location.
Probe is connected correctly.
19 / 31
19