909 909210TS Інструкція з експлуатації - Сторінка 14

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пила. 909 909210TS. 909 909210TS 18 сторінок. 1200w 210mm 8" table saw

Switching on and off

1. To Turn the unit ON, lift the

red stop knob up, and lift

the yellow cover.

2. To start the unit depress

the Green button. To Stop

the unit either depress the

red button on the main

switch or depress the Red

knob on the front.

The unit is fitted with an over

load protection device. If the

overload is initiated, Switch

the unit OFF at the mains,

wait for the unit to cool down.

Inspect for any damage.

Switch the unit back ON.

1. Set the saw blade to the

required cutting depth by

turning the blade depth

adjustment wheel (10)

2. Turning the wheel anti-

clockwise increases the

cutting depth.

3. Turning the wheel

clockwise decreases the

cutting depth.

Adjusting the angle of cut

1. Slacken the blade bevel locking knob (12).

2. Turn the blade bevel adjustment knob (11) until the

indicator points to the required angle on the scale.

3. Securely tighten the blade bevel locking knob (12).