DYNAPAR NorthStar WIND 56 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вимірювальні прилади DYNAPAR NorthStar WIND 56. DYNAPAR NorthStar WIND 56 12 сторінок. Magnetoresistive encoder for pitch control unit applications
Друкувати сторінку
1.1 General
These instructions do not claim to cover all details of variation in equipment or to provide for every possible
contingency or hazard to be met in connection with installation, operation, and service. Should further
information be desired or should particular problems arise which are not covered sufficiently for the
purchaser's purposes, please contact Dynapar., or one of its designated representatives.
1.2 Description
The NorthStar WIND56 is a modular digital encoder. This magnetoresistive encoder sensor-based unit has
been designed for fast, easy mounting onto a standard NEMA 56C motor face. The basic design philoso-
phy is as follows: The encoder frame is mounted onto the C-face flange of a motor. This positions the
sensor and contains the electronics. The magnetic pulse wheel on the motor shaft has magnetic pulses
imprinted on its outside surface. As the motor spins, the passing magnetic pulses actuate the
magnetoresistive sensor. The resulting electronic signals are processed into square wave signals by the
internal electronics.
9.45 (240.0)
7.53 (191.3)
+1.800.873.8731
©DYNAPAR
NorthStar WIND 56 Instruction Manual
2.75 (69.9)
2.75 (69.9)
5.50 (139.7)
Figure 1: Dimensions - inch (metric)
702820-0001 Rev. C
1.49 (37.9)
PROTECTIVE
COVER
WHEEL
Ø4.795
(121.8)
Ø5.165
Ø2.75
(131.2)
(69.9)
0.158
(4.0)
0.830
(21.1)
0.362
0.74 (18.8)
(9.2)
0.83 (21.1)
0.427
1.92 (48.8)
(10.9)
0.578
(14.7)
0.738
(18.8)
June 2012
Page 5