Galaxy Audio HDR2 Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Обладнання для запису Galaxy Audio HDR2. Galaxy Audio HDR2 14 сторінок. Galaxy audio handheld digital recorder instruction manual

Друкувати сторінку

The device allows you to record ONLY in FOLDER 1. To change to FOLDER 1,

press

mode. (1)

2. The device allows you to record into the internal flash memory or into an installed SD card

memory (2). The HDR2 will change to the SD card memory automatically when SD card

is installed. Or you can press

internal flash memory (F) and the SD card (C).

3. Press

4. Press

may select the blank track number you want to record to, then press

Or just press

recorded track number to record (for example, if the last recorded track number is 05, the

automatically selected track number will be 06).

5. Press

button to start recording, the Recording indicator LED will light up (their may be

a short delay after pressing REC button and seeing the indicators), and the time clock will

start running (5), which means that the recording is in progress. Press

record during recording, the Recording indicator LED will start flashing, press the same

button again to continue recording. Press

The volume indicator will show on the LCD during recording (6), you can adjust input

volume by the Volume controller of Audio-in (8 or 9). Be sure to watch the recording level.

Setting it too high may result in a distorted recording level.

7. When you finish recording, the recording format and sample rate of this track will show up on

the LCD. (7)

8. For extended time recording or playing, you can move the Key hold switch (14) to ON

position to disable all buttons and switch to the OFF position to enable all buttons. This

feature is useful to prevent accidental interruptions.

Record from microphones

The HDR2 is equipped with two built-in microphones (omni directional condenser type).

You may adjust the high/low sensitivity level of the built-in microphones using the Built-in

microphone sensitivity selector (13). The high sensitivity level of built-in microphone is at -

45dB (at 1KHz), while the low sensitivity level is at -35dB (at 1KHz). You may also adjust

the Volume control of Audio-in to make fine volume adjustments. ( 7 or 8 ).

2. There are two ¼" Audio-in jacks on the HDR2 ( 9 & 10 ). They allow you to plug two external

microphones into the jacks for recording. Select to "M" position of the Audio-in selector

(11). The two Audio-in jacks both provide DC 1.5V power. You may use either condenser

microphones or dynamic microphones as recording sources. The external microphone

record level is adjustable via the volume controls (7 or 8). The mic sensitivity switch (12)

has no effect on the external mics.

, when the LCD display shows FOLDER 1, you are in FOLDER 1

to select the group number in the range from 1 to 9. (3)

to select the recording track in the range from 01 to 99 to record (4). You

button directly, the device will select a blank track that follows the last

to interchange between the memory of the

button to finish recording.

button to record;

to pause