Autopage RF-503 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Автосигналізація Autopage RF-503. Autopage RF-503 16 сторінок. Remote transmitters
Також для Autopage RF-503: Посібник (2 сторінок)

Друкувати сторінку

E. PASSIVE OPERATION

The RF-503 provides a choice of arming capabilities. The alarm can be set to automatically arm each

time the vehicle is parked, or it may be armed manually. Refer to manual arming at the beginning of this

manual. The selection for PASSIVE (Automatic) or MANUAL (Active) arming is done with the

remote transmitter.

NOTE: THE RF-503 MUST BE DISARMED IN ORDER TO SELECT PASSIVE OR MANUAL

ARMING

NOTE: The factory default setting is MANUAL arming.

1. PASSIVE ARMING

Press the MODE button "M" plus Button II for three (3) seconds on the RF-503 remote transmitter.

The horn or siren will respond with three (3) chirps. Then press Button I. The horn or siren will

respond with four (4) chirps and immediately exit the mode. The alarm will now arm in the PASSIVE

(Automatic) mode each time the ignition is switched off. If no signal is received within 30 seconds, the

mode will automatically close.

1. Switch OFF the vehicle ignition, exit vehicle, and be sure all protected openings are closed.

2. The LED STATUS INDICATOR will begin fast flashing and the passive arming timer will begin

counting down.

3. If you reopen the exit, the LED will stop flashing.

4. Close the exit, and the LED will start flashing again.

5. The RF-503 will count down for 30 seconds. After 30 seconds, the vehicle horn or siren will chirp

one (1) time, and the parking lights will flash one (1) time indicating the RF-700 has armed.

NOTE: If the optional power door lock feature is installed, and the PASSIVE (Automatic) door lock

feature has been selected during installation, the doors will automatically lock 10 seconds after the

PASSIVE arming cycle is completed.

2. DISARMING WITH PASSIVE (AUTOMATIC) ARMING

Disarming is accomplished in the same manner as with MANUAL arming. Refer to Section A of this

manual.