Autopilot POOL PILOT SOFT TOUCH Експлуатація, усунення несправностей та технічна шпаргалка

Переглянути онлайн або завантажити pdf Експлуатація, усунення несправностей та технічна шпаргалка для Освітлювальне обладнання Autopilot POOL PILOT SOFT TOUCH. Autopilot POOL PILOT SOFT TOUCH 6 сторінок.

Друкувати сторінку
POOL PILOT
TROUBLESHOOTING AND TECHNICAL CHEAT SHEET
1. Output Lights will pulsate to indicate Chlorine production.
a. There are 7 lights to indicate output level.
b. Chlorine Production is based upon an on/off period of a 30-minute cycle.
c. If lights are solid Green this means unit is in rest mode.
d. To increase percentage of chlorine production, press UP ARROW
e. To decrease percentage of chlorine production, press DOWN ARROW
(The lights will display between 1 light up to 7 lights to reflect output level)
2. Flow Light will be Green
a. If Flow light is not on see troubleshooting section.
3. Salt Light will be Green (OK) – unit will produce chlorine
4. If Salt light is Yellow (LOW) add salt until Green Salt light comes on or check with Salt
addition chart for proper amount
5. If Salt light is Red (ADD) ---unit will engage safety cell shut off. Unit will automatically
resume operation when salt is added back to sufficient levels.
6. Pushing the BOOST BUTTON will increase chlorine production to 100% for 24 hours of
accumulative pump run time. The GREEN BOOST LIGHT will stay Solid Green
a. Holding the Boost Button down from Boost OFF mode for 8 seconds will increase the
Boost Cycle to 72 hours of accumulative pump run time. The Green Boost light will
flash
b. After Boost Cycle is complete the unit automatically reverts to the original Setting
c. Depress the Boost button in either Boost mode to deactivate Boost mode.
.
1/17/03
SOFT TOUCH
NORMAL OPERATING MODE OF SOFT TOUCH
i. The Yellow Salt light comes on at 2500 ppm and unit will still produce chlorine.
i. The Red Salt light comes on below 2000 ppm of salt.
OPERATING,
1