Galiso LDD-4 Інструкція з монтажу/експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з монтажу/експлуатації для Сушарка Galiso LDD-4. Galiso LDD-4 10 сторінок. Light duty dryer

5.0 OPERATION

A. Galiso, Inc. recommends a warm up time of approximately 2 minutes at the start-

up of the machine. Switch the Power Switch to the HEAT position. After the warm

up, the Power Switch can remain in the HEAT position, or be switched to COOL

or OFF

B. Check that the cylinders are emptied and drained of water.

C. Invert drained cylinder and place upside down with a manifold outlet inserted into

the cylinder neck.

D. When cylinders have been loaded, flip the Power Switch to the HEAT or COOL

position.

E. After cylinders have been drying for a short time (5-10 minutes), check each

cylinder for dryness, and replace on the dryer if necessary or, load the next

cylinder.

NOTE: Cylinder dry times can vary, depending on the size and/or material.

Galiso, Inc. recommends using the COOL setting for composite cylinders.

The dryer can remain "On" when changing out cylinders but

the operator should be careful to avoid touching the Manifold

Frame, as it may be hot.

F. To shut down at the end of the day, flip the Power Switch to "COOL" for

approximately 2 minutes for the unit to cool down before flipping to the "OFF"

position.

A. No regular maintenance is required except to check the air filter on top of the

muffler at least once a month and replace if needed.

Section 4 – 1

! CAUTION !

Avoid bending or otherwise damaging the tube.

! CAUTION !

21-11-1027