AUTOSCALER AW30C Посібник - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник для Конвертер мультимедіа AUTOSCALER AW30C. AUTOSCALER AW30C 14 сторінок.
Друкувати сторінкуRESPONSIBILITIES
It is the responsibility of the dental professional using this device to be
fully trained in the proper use of ultrasonic scalers. The operator must
be observant of possible changes in performance during a procedure
and immediately discontinue use of this product and determine the
cause of such changes in performance before continuing dental
procedures. Performance varies slightly between manufacturers of
ultrasonic scalers, so the operator must become familiar with the
operating parameters, and adjustments of this particular device.
Performance varies between Ultrasonic Inserts due to the style insert,
model insert, and from the age and/or modifications of the insert.
DAILY PROCEDURES
At the end of the work day shut off ALL operatory Air and Water
supplies. This will prevent water damage to your office by aging or
unseen defects in water lines that could rupture under continuous
pressure.
REMEMBER to turn back on the next day before usage.
SPECIAL PRECAUTIONS
As an added precaution, the water supply should be turned OFF at
the end of the day. REMEMBER to turn the water back ON prior to
use the next day.
The AUTOSCALER® should NOT be used for restorative dental
procedures involving the CONDENSATION OF AMALGAM.
The AUTOSCALER® should NOT be used on or near anyone fitted
with a CARDIAC PACEMAKER.
Do not remove the cover from the unit. There are NO user
serviceable parts inside. Allow only qualified technicians to service
your AUTOSCALER®.
Do not remove the internal air restrictor. This is a safety device
and must not be removed.
DO NOT AUTOCLAVE the HANDPIECE assembly. A Federally
approved non-immersion WATER BASED cold sterilization solution
may be used on the handpiece assembly. DRY ALL SURFACES with
clean air or clean paper towels.
If your unit is left ON, and the footswitch is accidentally depressed
while unattended, this will permanently damage your unit. Be sure
nothing is touching the operatory air foot switch when not in use.
17
INFECTION CONTROL
Manufacturer recommends that all operators of this ultrasonic
unit wear at least one pair of surgical rubber gloves, and for extra
prevention wear double pairs of gloves to isolate the operator
from infection, and cross contamination of other patients.
It is recommended that complete eye and face protection be used
during the use of this unit to prevent saliva spray from being
inhaled, and from entering the operator's eyes.
Operator should be careful not to puncture the skin with any
insert tip containing saliva from patients. Insert tips should be
sterilized after each patient according to the insert manufacturer's
instructions.
DO NOT Autoclave the handpiece assembly. Federally approved
non-immersion WATER BASED cold sterilization solutions may be
used on the handpiece assembly. DRY ALL SURFACES with clean air
or clean paper towels.
Manufacturer recommends the use of a disposable handpiece
sleeve/barrier that keeps contamination from getting on the
handpiece assembly. Dispose of sleeve/barrier after each patient.
Ask your local dealer for HIGH SPEED LONG sleeve/barrier.
INTRODUCTION
Your South East Instruments AUTOSCALER® Ultrasonic Scaler BUILD-IN
UNIT, is a precision engineered instrument, constructed with the finest
of materials. By taking the following precautions your unit will give you
many years of service.
The AUTOSCALER® BUILD-IN unit is NOT a table top user installation
product. It must be installed by a qualified technician knowledgeable
in Dental Operatory Air circuitry and Water systems.
1. Do not place unit on or near any source of heat.
2. Unit should be located where a normal amount of air will circulate
freely around the case when in use.
3. The handpiece is very strong but care should be taken NOT TO
PULL with excessive force.
18