Galvin Engineering 48785 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Сантехнічний виріб Galvin Engineering 48785. Galvin Engineering 48785 4 сторінки. Washing machine taps

Друкувати сторінку

Product Installation Guidelines

PRE-INSTALLATION -

Wall Spud

− Wall spuds must be 15BSP MI and protrude from the finished wall by no more than 15mm

Note: In some situations a male thread connection on the tap may be more suited. If so, please

contact Galvin Specialised on 1300 514 074.

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation

instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water

and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of

the product.

1. Fit washing machine body

−

Fit the washing machine body assembly to the

spud and fasten with a spanner.

−

We recommend using thread tape or

equivalent to ensure the connection does not

leak.

−

DO NOT tighten the body by using the top

assembly.

MOUNTING DETAILS

2. Fit handle

−

Ensure the spindle is in the closed position

then fit bonnet and handle

−

Secure the handle using the "C" circlip and

locking ring.

Version 1, 7 October 2022, Page 2 of 4