HIKOKI SB3608DA Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент HIKOKI SB3608DA. HIKOKI SB3608DA 20 сторінок.
Друкувати сторінкуREGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1–Fig. 17)
Handle knob
Housing
Sanding belt
Guard
Adjust screw
Belt cover
Slide fastener
Dust bag
Duct
Trigger switch
Lock on button
Elbow
Dial
Nameplate
Handle
Battery
Drive pulley
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
SB3608DA: Cordless Belt Sander
To reduce the risk of injury, user must read
instruction manual.
Direct current
V
Rated voltage
n
No-load speed
0
/min
Revolution or reciprocations per minute
Disconnect the battery
Switching ON
Switching OFF
10
Drive pulley rotation
direction arrow
(marking)
Lever
Idle pulley
Ventilation holes
Motor
Latch
Charge indicator lamp
Arrows on the inside of
the belt
Side of housing
Battery level indicator
switch
Battery level indicator
lamp
Air blow gun
Terminal (Battery)
Sliding grooves
Terminal (Product)
Battery sliding grooves