Maintronic DASPip UP Короткий посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Короткий посібник для Контролер Maintronic DASPip UP. Maintronic DASPip UP 6 сторінок. Power pwm actuator 1ch
Друкувати сторінку4.4 DALI-Commands
DALI parameter
Value range
Power On Level
0 – 100 % (0 – 254)
Brightness value after switching on
(DALI Wert 255 = MASK)
System Failure Level
0 – 100 % (0 – 254)
Brightness value when DALI-Signal Failure
(DALI Wert 255 = MASK)
Min Level
0 – 100 % (0 – 254)
smallest possible brightness value
Max Level
0 – 100 % (0 – 254)
maximum achievable brightness value
Fade Time
von 0 – 90,5 Sekunden
Speed when changing the brightness value
Fade Rate
von 1 – 72 Schritten/s
Steps for changes to the brightness value via
DALI command darker and brighter
4.5 smartGX (=smart Gear Xtensions) *
(*) Extended functions for DALI operating devices.
- Output characteristic - output calibration
- PWM-invert
- Power-On delay
- Power-Off delay
- Reverse relay switching state ...
The smartGX functions can be adjusted with the maintronic
DALI Device Manager software. This also requires a DALI USB
controller (DALI mouse).
5. button operation
Factory setting
The module can be operated via tastDIM with 230V at the DALI
100 %
input (see tastDIM 230V).
Tastendruck
100 %
short press
0,8 %
long press
100 %
2x short press
Press for 10 seconds Synchronization of the connected devices (see 5.2)
< 0,7 S
Press for 30 seconds Factory Reset (see 6.7)
4x short press
45 Schritte/s
5.1 tastDIM ** 230V-Pushbutton input
Alternatively, the DALI input can also be used with tastDIM.
tastDIM is a direct 230V AC pushbutton input with long press
function. For this purpose, a voltage of 230V AC is connected
to the DALI contact.
A mixed operation of DALI and tastDIM is not permitted.
(**) Button 230V against N at the DALI input (not SELV)!
Several push buttons can be connected parallel.
Several tastDIM-capable devices can be connected to a push-
button line.
IMPORTANT - When using the DALI input as tastDIM,
no further DALI operating device or DALI controller
may be connected in the same circuit since there is
230V input on the DALI input!
10
On- / Off
Dim the last memory level brightness
Dimming
Dimming up and down (start at min level)
Switch to Max Level
Programming Min-Level (see 5.3)
< 1s
< 1s
1
D1
L
230VAC
D2
N
5.2 Synchronize several devices on one
tastDIM(Pushbutton input):
If the button has been pressed for at least 10 seconds, all out-
puts are reset, the connected dimmers go to 50% for signaling.
11
> 1s
> 1s
2
3
4
12