Majacraft Little Gem Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Прядильні колеса Majacraft Little Gem. Majacraft Little Gem 8 сторінок.

Fit the lower drive belt next. Firstly place the belt in the groove on

the crank pulley. Once the belt is in the drive wheel groove as shown

in 5c, use your other hand to turn the drive wheel to wind the belt

into place.

6. Bobbin and flyer

Required:

1 - Plastic bobbin

1 - Delta flyer

If you have some petroleum jelly or vaseline, rub a

small smear onto the flyer shaft. This has already been

done at the factory so is not essential. Now slide the

bobbin on.

At this point screw the flyer on to the flyer shaft. It

may help to hold the whorl with your left hand and

tighten the flyer with your right (assuming you are

right handed). It may also be treadled on by holding

the flyer in one hand and treadling the wheel in an

anticlockwise direction.

If you are looking at the bamboo side of the drive wheel, you need

to put the belt on in such a way that the drive belt is closest on the

right hand side (shown by the arrow in image 5d). If the belt is put

on the other way, it will be more inclined to run backwards.

The tension spring should be positioned leaning to the

right hand side as shown in the picture.

majacraft