CentralPURE H2O CP-1000 Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Системи фільтрації води CentralPURE H2O CP-1000. CentralPURE H2O CP-1000 6 сторінок.

Друкувати сторінку

CP-1000

Keep the CP-1000 in an upright position at all times.

Reference the parts list and diagram during installation.

Remove the CP-1000 and all additional components from their boxes.

CAUTION: The CP-1000 is very heavy, exercise extreme care when lifting and

moving the unit – two people are suggested.

Remove any tape and/or foam plugs from the inlet (UPFLOW) and outlet

(DOWNFLOW) ports on the CP-1000 and the bypass valve.

Assemble the bypass valve assembly and two (2) elbow assemblies to the CP-1000.

No tools are needed to tighten the quick-connect nuts. The elbows can be rotated

freely even after they are fully tightened to the bypass valve. Ensure both red valves

are rotated to the fully closed position.

Locate the desired positioning for the components of your new purification system

and mount the pre-filter bracket to a wall or other supporting structure. Four (4)

galvanized lag shields (wall anchors) and lag screws are provided. The wall anchors

are for installing the bracket to concrete, brick or block surfaces. Use the four (4)

stainless steel lag screws to attach the top of the pre-filter housing to your bracket.

Turn off the water supply.

Assemble the true union ball valve and pre-filter housing to your incoming water line.

Make connections to the inlet side only of the CP-1000 (labeled UPFLOW) using the

nipples and CPVC union provided. Use the heavy-duty pink thread seal tape pro-

vided. CAUTION: Be careful not to overtighten any connections.

Install the 1-micron filter cartridge into the pre-filter assembly and secure the

sump/bowl with the pre-filter wrench.

Precondition the unit by flushing.

inlet side, temporarily connect the hose adapter assembly to the outlet side (labeled

DOWNFLOW) of the CP-1000. Attach a garden hose to the outlet port of the unit

using this adapter. Run the garden hose to a floor drain or utility sink to remove the

carbon fines and entrapped air from the unit. Slowly turn the water on at the ball

valve and the inlet valve only. When water fills the unit slowly open the outlet valve

to flush the system. On occasion, repeatedly open and close the inlet valve many

times to improve flushing effectiveness. Flush water through the unit for 30 to 60

minutes to remove the air and carbon fines. The darkness of the water during the

flushing process may be disturbing, but this is a normal process and not harmful.

The first few gallons will appear black, then the water will slowly begin to clear. The

media-swirl action within the CP-1000 is swirling and loosening the media in the two

separate stages. Continue flushing the unit until the water runs clear, then detach

the garden hose and hose adapter from the unit. Save your adapter for future use.

Installation Instructions

When all the connections have been made on the