Bristan Wine Easyfit Інструкція з монтажу та посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Сантехнічний виріб Bristan Wine Easyfit. Bristan Wine Easyfit 12 сторінок. Kitchen sink mixer

Друкувати сторінку
Installation Cont.
Identify all components are present prior to starting installation using the diagram on
page 06.
1.
Spout Assembly
2.
Spout Grub Screw
3.
Handle
4.
Indice
5.
Spline Adaptor
6.
CD Valve
7.
Grub Screw
8.
Cap
Flush through the pipework to ensure removal of debris. Turn off
the mains water supply and close any isolating valves.
1. Fit push-fit connector
Place the 'push-fit connector' into the hole in the basin top.
Ensure the rubber washer is fitted to the underside and the side
with 'FRONT' on is at the front.
2. Attach hot and cold connectors
A re-enforcing plate, (not supplied or shown in diagram) can be
used to distribute the weight of the tap if fitted to thin worktops or
stainless steel sinks. If required, this should be fitted underneath
work surface above the back nut. Position the back nut under the
basin (with the rubber seal on top), ensuring the locating pin fits
into the hole in the back nut. Insert and loosely tighten the
threaded cold connector by turning the 6mm hexagonal key
clockwise.
Note: The hot connector has 2 flat edges at the top to allow it to fit fully down and close to
the top of the cold connector. Failure to do this may prevent the tap fitting onto the connector.
Important: The push-fit connector must be fully tightened to the back nut before
attaching the flexible connecting pipes.
x1
9.
Grub Screw
x1
10.
Easy Fit Assembly
x2
11.
Flexible Connecting Pipes
x2
12.
Isolation Valve
x2
13.
Non-Return Valve
x2
14.
Fixing Plate
x2
15.
Hexagonal Key
x2
x2
x1
x2
x2
x2
x1
x1
07