Bristan Wine Easyfit Інструкція з монтажу та посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Сантехнічний виріб Bristan Wine Easyfit. Bristan Wine Easyfit 12 сторінок. Kitchen sink mixer

Друкувати сторінку

Installation Cont.

3. Attach flexible connecting pipes.

Important: Before connecting the flexible connecting

pipes, please refer to the specific installation

requirements on page 5. Carefully screw the 'flexible

connecting pipes' into the 'push-fit connectors'. Fit the

isolation valves (supplied) to the flexible connection pipes

and turn to the 'closed' position as shown on page 5.

Note: A flexible connecting pipe can be fed up through

the hot connector hole and then screwed on if required.

Important: Only tighten the flexible connecting pipe by

hand. Do not overtighten. Connect the isolation valves/flexible

connecting pipes to the household water supply pipes.

4. Cover cap

If required place the cover cap over the push-fit connector

until the tap body is ready to be fitted.

5. Fit the tap body

Remove the cover cap and place the plinth over the push-fit connector. Grease the push-fit

connector using the sachet of grease provided. Push-fit the tap body onto the connector.

Align the body and tighten the grub screw at the rear of the body, using the long end of the

2.5mm hexagonal key as shown below until finger tight. Remove the hexagonal key and

insert the short end into the grub screw and tighten an extra ¾ to 1 complete turn more to

ensure the tap body is securely tightened to the push-fit connector.

Important: The fitting must be securely attached to the base.

Turn on the mains water supply and open the isolating valves using a suitable flat blade

screwdriver. (See page 05)

Operation

Lowering/Lifting of the lever handles will turn on/off and increase/decrease the flow of water.

The swivel spout also allows for various positioning.

* Tap body may

vary to the one

shown here