Gamma X-ST Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma X-ST. Gamma X-ST 19 сторінок.
Також для Gamma X-ST: Посібник користувача (19 сторінок), Посібник користувача (19 сторінок)
Друкувати сторінку
ASSEMBLY INSTRUCTIONS
Remove and Discard Plastic Washers
Turntable Installation
To install the turntable remove the four nuts
underneath holding the mounting bolts in
place. Position the turntable over the turn-
table pin and align the bolts with the holes in
the flange. Secure them with the included
allen wrench.
Note: When purchased with the optional
floor stand, it is most convenient to attach the
base to the floor stand at this point. See
instructions provided with the optional floor
stand.
Support Post Installation
To install the support posts you must first
remove the mounting bolt from the mounting
plate that sets inside the central cavity of the
turntable. There are large holes stamped on
the underside of the turntable that allow you
to support the mounting plate with your
fingers while removing the mounting bolt.
Support Post Installation (con't)
After removing the mounting bolt, remove
and discard the plastic washers that are
installed for shipping purposes.
3