KitchenAid 3185891 Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Варильна поверхня KitchenAid 3185891. KitchenAid 3185891 5 сторінок. 30" and 36" gas sealed burner glass cooktop

Друкувати сторінку

30" cooktop

30" min. base cabinet

is required. If cabinet has

a drawer, a 3-l/2" depth clearance from the

countertop to the top of the drawer (or other

obstruction)

in base cabinet is required.

36" Cooktop

36" min. base cabinet

is required.

If cabinet

has a drawer, a 3-l/2" depth clearance from the

countertop to the top of the drawer (or other

obstruction)

in base cabinet is required.

Fire Hazard

-I

Do Not obstruct

the flow of combustion

and ventilation

air.

Personal

Injury Hazard

Avoid installing

cabinet

storage

above the

cooking

surface.

If cabinets

are already

installed,

reduce the hazard of reaching

over a heated cooking

surface

installing

a range hood. The range hood

should

extend a minimum

of 5 inches out

from the bottom front of the cabinets.

Reaching

over a heated cooking

surface

could result in a serious

burn or other

personal

injury.

WARNING: If the information in this

manual is not followed exactly, a

fire or explosion may result

causing property damage, personal

injury or death.

Electrical

Shock Hazard

It is the customer's

responsibility:

To contact

a qualified

electrical

installer.

To assure that electrical

installation

adequate

and in conformance

with

National

Electrical

Code ANSI/NFPA

latest edition and all local codes

and ordinances.

- Do Not store or use gasoline or

other flammable vapors and

liquids in the vicinity of this or

any other appliance.

- WHAT TO DO IF YOU SMELL

GAS

Do Not try to light any

appliance.

Failure to do so could result in fire, .

electrical

shock or other personal

mlury.

Take special

care when drilling

holes into

the wall for electrical

wiring.

Electrical

wires may be concealed

behind the wall

covering.

Failure to do so could result in fire,

electrical

shock or other personal

injury.

Do Not touch any electrical

switch; do not use any phone

in your building.

Immediately call your gas

supplier from a neighbor's

phone. Follow the gas

supplier's instructions.

If you cannot reach your gas

supplier, call the fire

department.

For 30" cooktop - 30" min. cabinet width

above

C0ddOD

For 36" cooktbp

- 36" min. cabinet

width

above c0DMop

13" max.

upper

cabinet

depth

minimum

clearances

cabinet to countertop

countertop

combustible

Do Not pinch the power

SUDDIV

Note: 30" min. when bottok

of ' /

wood

or metal cabinet is

cord beiween the'cooktop &i

cabinets.

protected

by not less than l/4"

flame retardant millboard

covered with not less than No.

28 MSG sheet steel, 0.015"

stainless steel, 0.024"

aluminum

or 0.020" copper.

Note: Clearances

specified are for combustible

walls and materials that have a density of 20 or

more pounds per cubic foot. No evaluation of

clearances

has been made for installations

adjacent to materials that are less than 20

unprotected wood or metal

sheet.

For new installations:

2-5/8" min. cabinet

space to backsplash

vertical

wall

2-310" min. space to

front edge of

countertop

S-114" min. cabinet

space both sides of

cooktop

from a

combustible

surface

Panel

2-5/a" min. cabinet

space to

backsplash

or vertical wall

2-318"

min. s ace to

front edge 0 P

countertop

4-518" min. cabinet

space both sides of

cooktop from a

combustible surface

pounds per cu. ft. or to plastic tiles and sheeting.

For replacement installations:

30" cooktop:

36" Cooktop:

18314" min., 20-518" max.

18-314" min., 2&S/8"

opening depth

opening

depth

26-112" min., 29518" max.

33" min., 34-710" max.

opening

width

opening width

Mobile

home installation

The installation of this cooktop must conform to the

Manufactured

Home Construction

and Safety

Standards, Title 24 CFR, Pat-l 3280 (formerly the

Federal Standard for Mobile Home Construction

and

Safety, Title 24, HUD Part 280); or when such

standard is not applicable,

the Standard for

Manufactured

Home Installations

1982

(Manufactured

Home Sites, Communities

and

Setups), ANSI A225, l/NFPA 501 A -

1987, or latest

edition, or with local codes.

Copies of the standards listed may be obtained from:

National

Fire Protection

Association

Batterymarch

Park

Quincy,

Massachusetts

02269

* American

Gas Association

1515 Wilson Boulevard

Arlington,

Virginia

22209

Before you start...

- Installation and service must

be performed by a qualified

installer, service agency or the

gas supplier.

Proper installation

is your responsibility.

Make sure

you have everything

necessary for correct

installation.

It is the responsibility

of the installer to

comply with the installation clearances

specified on

the serial/rating

plate. The serial/rating

plate can be

found on the bottom of the cooktop burner box.

Check location

where cooktop will be installed. The

location should be away from strong draft areas,

such

windows. The cooktop should be located for

convenient

use in the kitchen.

ALL OPENINGS

IN THE WALL OR FLOOR WHERE

THE COOKTOP

IS TO BE INSTALLED

MUST BE

SEALED.

Grounded

electrical

outlet is required. See

"Electrical requirements."

Proper gas supply

connection

must be available.

See "Gas supply requirements."

Countertop

opening

dimensions

that are shown

must be used. Given dimensions provide required 0"

clearance.

Cabinet construction:

This appliance

is designed

for use in a base cabinet with a depth of 24"

The

maximum depth for overhead cabinets is 13". The

minimum vertical clearance between the cooking

surface and the overhead cabinets is 30". Overhead

cabinets installed at either side of the appliance

must

be a minimum of 18" above the cooking surface. The

minimum distance between the front edge of the

countertop and the front edge of the cooktop is 3/4".

The minimum horizontal distance between the

overhead cabinets above the appliance are shown

for your model number.

New installations

follow minimum dimensions

given.

Replacement

installations

- Be sure that front

edge of cooktop is at least 1 -l/2" back from front

edge of countertop.

When installing

cooktop

over a built-under

oven.

Do Not fasten cooktop to countertop with clamps.

Cooktop then will be easy to remove if servicing is

ever necessary.

Note: The sealed gas cooktop is manufactured

for

use with NATURAL gas. Conversion to L.P. gas can

be made with Kit No. 4173627, available from your

KitchenAid dealer or authorized parts distributor.

Important:

Observe

all governing

codes and

ordinances.

Failure to meet codes and

ordinances

could lead to fire or electrical

shock.