Major Manufacturing HIT-66-274 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Токарний верстат. Major Manufacturing HIT-66-274. Major Manufacturing HIT-66-274 10 сторінок. Template for sargent “in” series cylindrical lock

Slide the HIT-66 clamp
system onto the door
with the "U" shaped
guide over the blue
alignment plug. Tighten
the clamps by alternat-
ing between the top
and bottom clamp. Do
not tighten one clamp
all the way at once.
Start by drilling the
two post holes with a
7/16" twist drill. Drill
half way from both
sides of the door. If
this is a retro fit it is a
good idea to re-drill
these holes if they
are on the door. This
will ensure they are
straight and true.
With a 5/32" twist drill,
drill the holes for
anchor lugs using the
holes located at 3:00
and 9:00 positions.
Drill about 3/16" into a
wood door. On a steel
door you may need to
open the hole into a
notch with the use of
a file prior to installing
the lock.
Copyright 2016
Major Manufacturing Inc
PAGE 5
PAGE 5