Centurion D2 Turbo Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з монтажу для Відкривач воріт Centurion D2 Turbo. Centurion D2 Turbo 9 сторінок. Domestic sliding gate operator
theft-resistant nut and padlock kit
Також для Centurion D2 Turbo: Посібник зі встановлення кишенькових пристроїв (13 сторінок), Посібник зі встановлення кишенькових пристроїв (2 сторінок), Посібник з монтажу (2 сторінок)
Друкувати сторінку
The pinion guard is
easily removed and
rotated allowing the rack
to be fitted above or
below the pinion.
8B.5. Use the orange height-
adjustment nuts
provided to level the
gearbox.
8B.6. Tighten the hold-down
nuts when the gearbox is
in the correct position.
Theft-resistant
Nut and Discus
padlock are
available from
Centurion System
for sites requiring
additional
security.
8B.7. Mount gate origin
marker to rack as per
illustration C, D and E,
with the gate in the
closed position.
Take care with the
orientation of the arrow
on the origin marker.
This arrow must face the
operator.
8B.8. Battery is fitted between
the motor enclosure
unit and the D2 Turbo
Low-Voltage controller.
8B.9. Unclip the orange clips
holding the controller
onto the motor enclosure
unit.
8B.10. Fit the 7Ah/5Ah battery
and clip the orange clips
down to secure the
battery in place.
Stud
locknut
(M10 half-height nut)
C: Isometric view
Greater than 500mm
D: Plan view
Greater than 500mm
Turbo
Origin marker
E: Plan view
10-17mm
Origin sensor
inside motor
enclosure
Hold-
down
nuts
(M10
nuts)
Orange
height-
adjustment
nuts
Washer
Discus
padlock
Theft-
resistant
Nut
Gate in
closed
position
Origin
marker
Gate
Rack
Turbo
Unclip
orange
battery
clip
Fit the
7Ah/5Ah
battery
Clip
orange
battery
clip to
secure