IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD Інструкція з монтажу та інструкція з експлуатації та догляду - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з експлуатації та догляду для Вентиляційна витяжка IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD. IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD 44 сторінки. 30" (76.2 cm) wall-mount canopy range hood

Друкувати сторінку

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1. Disconnect power.

2. Remove terminal box cover using a T10 Torx

T10 adapter provided) to remove screws.

3. Remove the knockout in the terminal box and install a UL

listed or CSA approved

A. Knockout

B. Terminal box

C. Terminal box cover

4. Run home power supply cable through strain relief, into

terminal box.

A. Home power supply cable

B. UL listed or CSA approved strain relief

C. Black wires

D. UL listed wire connectors

E. White wires

F. Green (or bare) and yellow-green ground wires

drive (or the

" strain relief.

5. Use UL listed wire connectors and connect black wires (C)

together.

6. Use UL listed wire connectors and connect white wires (E)

together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire

in terminal box.

Failure to do so can result in death or electrical shock.

7. Connect green (or bare) ground wire from home power supply

to yellow-green ground wire (F) in terminal box using UL listed

wire connectors.

8. Tighten strain relief screw.

9. Install terminal box cover.

10. Check that all light bulbs are secure in their sockets.

11. Reconnect power.

Install Vent Covers

When using both upper and lower vent covers, push lower cover

down onto hood and lift upper cover to ceiling. Install with 2 - 4.2

x 8 mm T20

screws using a T20

provided) to tighten.

NOTE: For vented installations, the upper vent cover may be

reversed to hide slots.

A. Bracket

B. 4.2 x 8 mm T20

C. Vent cover

Torx

drive (or T20

adapter

screws