decorflame QC810 Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електричний обігрівач decorflame QC810. decorflame QC810 6 сторінок. Electric stove heater

Друкувати сторінку

After reading complete instructions, confirm

that all controls on fireplace are in the OFF

position. Plug the fireplace into a 15 AMP/120

Volt outlet. If the cord does not reach, you may

use an extension cord rated for a minimum of

1875 WATTS.

NOTE: Every time the electric heater is

plugged in, it will beep once. This means the

heater has connected to the power outlet. The

Electric Fireplace Heater is ready to operate.

NOTE: ensure the circuit breakers for the

power supply are turned on. The electrical

fireplace heater can be operated from the

control panel and/or operated by the remote

control. See the following:

OPERATION bY THE

CONTROL PANEL

Controls and switches are located inside the

glass door.

FIRE: Press this button for main power and

flame effect, the unit will beep, then the

indicator light will turn on. The flame intensity

is controlled by a 3-level electronic control.

To increase the flame intensity, press and

release this button. When the flame intensity

reaches maximum, press once again to stop.

750W: For low heat function - Press this but-

ton while the FIRE button is on. The unit will

beep and give low heat level.

1500W: For high heat function - Press this

button while the FIRE button is on. The unit

will beep and the fireplace heater will give

high heat level.

O P E R A T I O N

TEMPERATURE DIAL: To adjust the tempera-

ture to your individual requirements. Turn

the thermostat dial to the right (clockwise) to

increase the desired temperature and to the

left for lower temperature. When the heater

reaches the desired temperature, the heater

will turn off but the fan will continue to oper-

ate. Adjust this knob to restart the heater.

OPERATION bY

REMOTE CONTROL

Press this button for main power and flame

effect. The unit will beep and the indicator

light will turn on. Press once again to stop the

unit.

750W: For low heat function – Press this but-

ton while the FIRE button is on. The unit will

beep and give a low heat level.

1500W: For high heat function – Press this

button while the FIRE button is on. The unit

will beep and give a high heat level.

+ : Press this button to increase the flame

intensity.

– : Press this button to decrease the flame

intensity.