Avantco 178MC58HC Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка Avantco 178MC58HC. Avantco 178MC58HC 9 сторінок. School milk cooler
Також для Avantco 178MC58HC: Посібник користувача (9 сторінок)

Avantco 178MC58HC Посібник користувача
Safety
This unit is intended for use in a temperature-controlled environment less than 75 degrees
Fahrenheit and 60% relative humidity. Malfunction due to improper conditions is not covered
under warranty.
IMPORTANT –
Please Read Before Installation:
If the unit has recently been transported on its side, please let the unit stand upright for a minimum
of 24 hours before plugging it in.
Make sure that the unit has reached the desired temperature before loading the unit with products.
This unit is meant for keeping cold products cold, not chilling warm products.
Make sure that there is proper ventilation around the unit in the area where it will operate.
Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit in.
Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing/repair.
Do not sit/stand inside the unit.
Please read through the manual in its entirety.
This unit is designed to perform in a temperature-controlled environment at 60% relative humidity.
The unit should be located away from doors, air ducts, and fans that could disrupt airflow and
negatively impact performance.

Cabinet Location Guidelines

Install the unit on strong and leveled surfaces.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
Install the unit in an indoor, well-ventilated area.
- For best performance, please maintain clearance of 4" on the back of the unit.
- Do not use outdoors. For indoor use only.
- Avoid direct sunlight.
Avoid installation in a high humidity and/or dusty area.
- Humidity above 60% can cause the unit to rust, collect condensation, and may decrease efficiency.
- Dust collected on the condenser coil will cause the unit to malfunction.
- Malfunctions due to temperatures above 75 degrees Fahrenheit, humidity above 60%,
or improperly maintained condenser coil will void the warranty.
Select a location away from heat and moisture-generating equipment.
- Ambient temperatures above 75 degrees Fahrenheit may cause the compressor to malfunction.
- The unit should not be used in areas over 90 degrees Fahrenheit.
- Malfunctions due to ambient temperatures above 75 degrees Fahrenheit will void the warranty.
- Do not install the unit inside a closet or alcove
www.AvantcoRefrigeration.com
4
User Manual
Commercial School Milk Coolers