Avantco 178UDD60HCS Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка Avantco 178UDD60HCS. Avantco 178UDD60HCS 19 сторінок. Beer dispensers
Також для Avantco 178UDD60HCS: Посібник користувача (19 сторінок), Посібник користувача (19 сторінок)

Avantco 178UDD60HCS Посібник користувача
User Manual
Storage & Handling
Draft beer should be treated as a food product. In most instances draft beer is not pasteurized. It is
very important that you store and handle it properly. Follow these steps to ensure the highest quality,
safety, and consumer satisfaction.
- Draft beer should be immediately stored in a refrigerated cabinet.
- Draft beer products have a recommended shelf life. If you have questions regarding the shelf life
of any of your draft products, please consult with your supplying depot or respective brewery
representative.
- Kegs should be stored separately from food products. If your cooler is used to refrigerate draft
and food products, it is very important that the food not be stored near or on the kegs.
- Keg storage and dispensing areas should be kept clean to prevent any possibility of contaminating
your products.
Knockout CO
These is the recommended procedure for
installing a remote CO
1. Remove black knockout plug with pliers. (See images below for plug locations)
2. Use drill with 1/2" bit to bore a whole straight back through wall into compressor compartment.
3. Snake CO
line through hole, down and around, exiting behind rear caster underneath grill.
2
4. Seal hole around CO
*Depending on setup and amount of kegs, a CO
NOTE: In models UDD1 & UDD1S, the CO
to maintain complete mobility
CAUTION
CO
tanks are potentially dangerous because of the pressure they contain. If you are unfamiliar with
2
their use or the use of a CO
before proceeding.
Installation
2
container in your Avantco unit.
2
line with silicone sealer to prevent cold air leakage.
2
tank (up to 5 lbs. in size) can be placed inside the cooler
2
regulator, seek information from your local distributor, or beverage man
2
Tools:
-
Pliers
-
Power Drill
-
Silicone Sealer
-
1/2" Drill Bit
manifold may be needed.
2
- 10 -