Avantco 178UDD60HCS Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка Avantco 178UDD60HCS. Avantco 178UDD60HCS 19 сторінок. Beer dispensers
Також для Avantco 178UDD60HCS: Посібник користувача (19 сторінок), Посібник користувача (19 сторінок)
Друкувати сторінку
Changing CO
Follow these instructions at ALL times when you replace a CO
1. Close cylinder at A.
2. Remove tap D from keg. Pull pressure release ring on body of tap to release pressure
remaining in line. (do not close C)
3. Remove or loosen regulator key B by turning counter clockwise.
4. Remove regulator from used cilinder at E.
5. Remove dust cap from new gas cylinder at E and clear dust from outlet by opening and closing
valve A quickly using appropriate wrench.
6. Attach regulator to new cylinder at E. (use new fiber/plastic washer, if required).
7. Open valve A all the way.
8. Close valve C.
9. Adjust regulator key B by turning clockwise to set pressure. (check setting by opening C
and pulling and releasing the ring F on the pressure release valve on the body of the tap).
10. Tap keg at D with valve C open.
Note: DO NOT drop cylinders. DO NOT lay cylinders flat.
It requires 1/2 lb. of CO
with 15 lbs. of pressure on barrel.
Pressure Adjustment on CO
Increasing Pressure:
1. Close regulator shut-off C.
2. Turn regulator key B clockwise and make setting.
3. Tap gauge for accurate reading.
4. Open regulator shut-off C and draw beer.
Decreasing Pressure:
1. Close regulator shut-off C.
2. Untap keg at D and activate tap handle to
bleed line. Leave in open position.
3. Slowly open regulator shut-off C and
simultaneously turn regulator key
counter-clockwise to zero reading.
4. Close regulator shut-off C and set pressure by
turning regulator key clockwise. Check setting
by opening and closing valve C.
5. Close tap head D. (put in OFF position)
6. Tap keg at D and open regulator shut-off C.
Gas Cylinder
2
to dispense 1/2 barrel of beer at 38°F
2
User Manual
gas cylinder.
2
Regulator
2
(May vary based on regulator design)
- 11 -