Makita 3901 Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3901. Makita 3901 16 сторінок. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Також для Makita 3901: Брошура (1 сторінок), Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (17 сторінок)
Друкувати сторінку
CAUTl
ON:
Before trimming the panels, check the wall or ceiling carefully to avoid cutting the electrical
wires, nails or other foreign materials.
*Always reinstall the rubber facing after trimming the panels. If cutting slots for biscuits
without the rubber facing installed properly on the tool, the tool might slip unexpectedly
on the workpiece, causing dangerous loss of control of the tool. When installing the rubber
facing, always hook
it
onto the inside of the front opening.
Removing or installing the blade
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the blade.
To remove the blade, loosen the clamp screw
and open the blade cover. Push the shaft lock
and loosen the lock nut using the lock nut
wrench.
To install the blade, first mount the inner
flange.
CAUTION:
When installing the cutter blade, mount the
inner flange with the side marked "22"
facing toward you.
When installing the circular saw blade,
mount the inner flange with the side
marked "22" facing toward the tool.
Lock
nut
- @
Cutter blade
Inner flange
Blade coyer
Then mount the blade and the lock nut. Securely tighten the lock nut using the lock nut
wrench. Close the blade cover and tighten the clamp screw to secure the blade cover.
CAUTl ON:
*Use only the Makita lock nut wrench provided to remove or install the blade.
*Always check the depth of cut after replacing the blade. Readjust it if necessary.
12