Makita 4326M Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 4326M. Makita 4326M 13 сторінок. Jig saw
Також для Makita 4326M: Технічні характеристики (2 сторінок), Технічна інформація (7 сторінок)
Друкувати сторінку
To install the blade, loosen the bolt counterclockwise on
the blade holder with the hex wrench.
With the blade teeth facing forward, insert the blade into
the blade holder as far as it will go. Make sure that the
back edge of the blade fits into the roller. Then tighten
the bolt clockwise to secure the blade.
1
2
► 1 . Bolt 2. Blade 3. Roller
To remove the blade, follow the installation procedure
in reverse.
NOTE:
•
Occasionally lubricate the roller.
Hex wrench storage
► 1 . Hook 2. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Adjusting roller (For models
4326/4326M/4327/4327M)
3
► 1 . Blade 2. Roller 3. Retainer 4. Hex wrench 5. Bolt
Loosen the bolt on the back of the base with the hex
wrench. Move the retainer so that the roller contacts the
blade lightly. Then tighten the bolt to secure the base
and the retainer.
NOTE:
•
Dust cover
1
2
► 1 . Dust cover
•
Lower the dust cover to prevent chips from flying.
However, when making bevel cuts, raise it all the way.
6 ENGLISH
2
1
6. Base
Occasionally lubricate the roller.
1
CAUTION:
Always wear safety goggles even when operat-
ing the tool with the dust cover lowered.
3
4
5
6