GarageAce R5 Інструкція з монтажу Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Відкривач гаражних дверей GarageAce R5. GarageAce R5 20 сторінок. Roller garage door opener
Друкувати сторінку14.6 Installation Direction Setting
Press and hold the "SET" button for 3 seconds until the LED flashes "1".
Press "UP" or "DOWN" to increase or decrease, adjust the LED to flash
"5", then press "SET" button.
It displays "R" or " L", hold down the "UP" or "Down" button, you can switch
directly. Choose the function which you need, press the "SET" button, the
LED displays the current setting.
NOTE: "L" means left installation, "R" means right installation.
14.7 Lock Door Setting (optional function)
(Only when the lock door function is available, the setting can be proceed.
The "lock" key cannot be matched)
Press and hold the "SET" button for 3 seconds until the LED flashes "1".
Press "UP" or "DOWN" button to increase or decrease. Adjust the LED to
flash "6", press "SET" button to enter into Lock Door Setting. The LED
displays the current setting.
Press "UP" button, the LED displays "1", the lock door function is on. Press
"DOWN" button, the LED displays "0", the lock door function is off. Press
"SET" button to confirm, the opener returns to standby mode.
When the lock door function is on and the door is fully closed, the opener
will lock the door automatically. And then the door can only be opened by
transmitter after unlocked by the "lock" key(S2) on the transmitter. (If not
unlocked by the S2 button on the transmitter, the light will flash twice when
pressing the open key on the transmitter)
The default setting is: invalid.
14.8 Half-open Setting (optional function)
(Only when the half-open function is available, the setting can be proceed.
The half-open key on the transmitter cannot be matched)
Press and hold the "SET" button for 3 seconds until the LED flashes "1".
Press "UP" or "DOWN" button to increase or decrease. Adjust the LED to
flash "7". Press "SET" button to enter into half-open setting. The LED
displays the current setting.
Press "UP" or "DOWN" button to increase or decrease. When the LED
displays "1", the half-open height is 30cm. When the LED displays "2", the
half-open height is 60cm. When the LED displays "3", the half-open height
is 90cm. When the LED displays "0", the half-open function is off. Press
"SET" button to confirm, the opener returns to standby mode.
If the half-open function is on, only when the door is fully closed, the door
can half-open by the "S1" key on the transmitter. If the door is at other
position, the "S1" key will not work.
The default setting is : invalid.
14.9 9. Alarm and Maintenance Function
When the LED flashes "A", this means opener working circle exceeds the
maximum safety and will need maintenance. Contact the maintainers.
13