GarageAce R5 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} GarageAce R5에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce R5 20 페이지. Roller garage door opener

14.6 Installation Direction Setting

Press and hold the "SET" button for 3 seconds until the LED flashes "1".

Press "UP" or "DOWN" to increase or decrease, adjust the LED to flash

"5", then press "SET" button.

It displays "R" or " L", hold down the "UP" or "Down" button, you can switch

directly. Choose the function which you need, press the "SET" button, the

LED displays the current setting.

NOTE: "L" means left installation, "R" means right installation.

14.7 Lock Door Setting (optional function)

(Only when the lock door function is available, the setting can be proceed.

The "lock" key cannot be matched)

Press and hold the "SET" button for 3 seconds until the LED flashes "1".

Press "UP" or "DOWN" button to increase or decrease. Adjust the LED to

flash "6", press "SET" button to enter into Lock Door Setting. The LED

displays the current setting.

Press "UP" button, the LED displays "1", the lock door function is on. Press

"DOWN" button, the LED displays "0", the lock door function is off. Press

"SET" button to confirm, the opener returns to standby mode.

When the lock door function is on and the door is fully closed, the opener

will lock the door automatically. And then the door can only be opened by

transmitter after unlocked by the "lock" key(S2) on the transmitter. (If not

unlocked by the S2 button on the transmitter, the light will flash twice when

pressing the open key on the transmitter)

The default setting is: invalid.

14.8 Half-open Setting (optional function)

(Only when the half-open function is available, the setting can be proceed.

The half-open key on the transmitter cannot be matched)

Press and hold the "SET" button for 3 seconds until the LED flashes "1".

Press "UP" or "DOWN" button to increase or decrease. Adjust the LED to

flash "7". Press "SET" button to enter into half-open setting. The LED

displays the current setting.

Press "UP" or "DOWN" button to increase or decrease. When the LED

displays "1", the half-open height is 30cm. When the LED displays "2", the

half-open height is 60cm. When the LED displays "3", the half-open height

is 90cm. When the LED displays "0", the half-open function is off. Press

"SET" button to confirm, the opener returns to standby mode.

If the half-open function is on, only when the door is fully closed, the door

can half-open by the "S1" key on the transmitter. If the door is at other

position, the "S1" key will not work.

The default setting is : invalid.

14.9 9. Alarm and Maintenance Function

When the LED flashes "A", this means opener working circle exceeds the

maximum safety and will need maintenance. Contact the maintainers.