GarageAce R5 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} GarageAce R5에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce R5 20 페이지. Roller garage door opener

Connect the power:

•

Position the power cable away from the door curtain and any moving

parts.

•

Plug the opener into a nearby power point and turn ON.

•

The opener courtesy LEDs should turn ON.

•

The opener must now be programmed for :

1. DOOR TRAVEL LIMITS (Section 14.2)

2. RIGHT OR LEFT HAND OPERATION (Section 14.6)

3. FORCE SETTING (Section 14.3)

14. Basic Function Setting and Applying

14.1 Learning the Receiver and Transmitter

Coding Transmitters:

Press and hold the "Code"button for 1 second until the led dot is on. Press

button on transmitter once, the dot will go off, press the same transmitter

button again and the dot will flash fast several times, and then return to

standby mode. The transmitter is now coded into the receiver.

Repeat the above steps to code more transmitters. The receiver has the

capacity to store 20 transmitters.

If the LED display flashes "F" and returns to standby mode (after you have

pressed the Code button), this indicates that the memory storage is full (20

transmitters). Follow the steps below to delete all transmitters that are stored in

the receiver memory: Press and hold on"CODE"button for more than 8

seconds until the LED flashes "C", all the stored codes are deleted. Only the

matched switch on the transmitter is available.

NOTE: If failed to match the transmitter within 20 seconds, then it will return to

standby mode automatically.

14.2 Travel Limit Setting Opening & Closing Force Self-learning

Press and hold the "SET" button for 3 seconds until the LED flashes "1". Press

"SET" button again for 1 second. "1" should now display as steady (not

flashing).

Then adjust the up limit by pressing "UP" button.

Fine-tune "UP" or "DOWN" button to determine the final up limit position (the

LED flashes "n" or "u" during opening or closing), then press "SET" button, the

display will show "2" automatically.

Adjust the down limit by pressing "DOWN" button.

Fine-tune "UP" or "DOWN" button to determine the final down limit position (the

LED flashes "n" or "u" during opening or closing), then press "SET" button.

When pressing the button to operate the opener, if the opener stops after

moving a little, and LED flashes "H" or "C", this indicates there is no hall signal

or the opener is overloaded.