GARAN EWS-102 Налаштування системи

Переглянути онлайн або завантажити pdf Налаштування системи для Блок управління GARAN EWS-102. GARAN EWS-102 4 сторінки.
Також для GARAN EWS-102: Налаштування системи (4 сторінок), Калібрування та налаштування (8 сторінок), Додаткова інформація (2 сторінок), Налаштування системи (4 сторінок)

Друкувати сторінку

EWS-102 CONTROL UNIT

To begin the system

setup, press the

buttons together.

Enter the system setup menu.

Select the first menu item.

CAP indicates the elevator maximum capacity. To view the current value press

AL 1 is the load value to trigger Alarm Relay 1. To view the current value press .

AL 2 is the load value to trigger Alarm Relay 2. To view the current value press .

AL 3 is similar to Alarms 1 & 2 but allows negative values to be entered. When editing the most

significant digit, instead of rolling over from 9 to 0 it included the minus sign option.

This defines the value by which the load in the lift has to drop to reset the instrument, once the

alarm has been triggered.

The next item is an auto zero function used to compensate for longer term zero drift. It defines

how long the elevator must be at rest before the zero point is redefined.

*If 'OFF' displayed. Press

to toggle to 'on'

This defines the deviation allowed for the longer term deviation function (maximum value

+/-99kg). Press

The filter value determines the update rate and damping factor. The available settings are:

0 = 0.4sec, 1 = 0.8sec, 2 = 1.2sec, 3 = 1.6sec.

An internal sounder beeps when an overload alarm is triggered or when the keypad is pressed. To

change the setting, press and use to toggle between ON and OFF.

Save the change by pressing

Rev 2.1 subject to alteration

and

to view the current value. Press

The system setup menu allows you to set and adjust various

system parameters.

Navigation

Use the button to step through the menu items.

Press to view the value of a menu item.

Editing Values

When a value is displayed, use to select the digit to edit

(selected digit flashes) and use to step through the values

for that digit.

Press

to save a change. The system will revert to the

operational display after approx. 10 seconds. Alternatively,

return to the operational display by pressing

Press to toggle to 'OFF' if you wish to disable the function,

and press

to jump to 'FIL'

This is the current value (example is 1 hour) that defines the

time that the elevator must be empty for (in hours up to a

maximum of 10 hours). Press

value, and then press

to save it and move to the allowed

deviation setting.

again to edit the value.

SYSTEM SETUP

twice.

if you wish to change the