CORNING UAT3 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Інструменти CORNING UAT3. CORNING UAT3 18 сторінок.

Друкувати сторінку
CAUTION: The tool must be driven with the handle. do not
pull the tool or attempt to drive it with power tools.
5.3
To initially prepare the tool for use:
a. Use the thumbscrew to open the tool to at least 0.25 in more
than the diameter of the tube to be accessed (Figure 7).
NOTE: In the following steps, a recommended blade setting is
referenced. In most cases you will have to make adjustments to
the blade setting while slitting the buffer tube to get the desired
depth of cut.
b. For the tool to operate correctly, the blade depth adjustment
must be made (or verified) prior to accessing any tube.
Determine the buffer tube diameter using either Table 1 or
the plastic gauge card supplied with the tool kit.
Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 7 of 18
Drive shaft
Figure 6
Figure 7