Makita AN611 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita AN611. Makita AN611 13 сторінок. Construction coil nailer
Також для Makita AN611: Інструкція з експлуатації (19 сторінок), Розбивка на частини (4 сторінок), Розбивка на частини (4 сторінок), Інструкція з експлуатації (12 сторінок)
Друкувати сторінку
To maintain product SAFETY and RELIABILITY,
•
maintenance and repairs should be performed by
Makita Authorized Service Centers, always using
Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
INSTALLATION
Selecting compressor
(L/min)
120
100
80
60
40
20
0
10 20 30 40 50 60
Nailing frequency
005236
Select a compressor that has ample pressure and
•
air output to assure cost-efficient operation. The
graph shows the relation between nailing frequency,
applicable pressure and compressor air output.
Thus, for example, if nailing takes place at a rate of
approximately
50
compression of 0.59 Mpa (5.9 bar), a compressor
with an air output over 80 liters/ minute is required.
Pressure regulators must be used to limit air
pressure to the rated pressure of the tool where air
supply pressure exceeds the tool's rated pressure.
Failure to do so may result in serious injury to tool
operator or persons in the vicinity.
(times/min)
times
per
minute
Selecting air hose
004294
Use an air hose as large and as short as possible to
•
assure continuous, efficient nailing operation. With
an air pressure of 0.49 Mpa (4.9 bar), an air hose
with an internal diameter of over 6.5 mm and a
length of less than 20 m (6.6 ft.) is recommended
when the interval between each nailing is 0.5
seconds. Air supply hoses shall have a minimum
working pressure rating of 1.03 Mpa (10.3 bar) or
150 percent of the maximum pressure produced in
the system whichever is higher.
CAUTION:
Low air output of the compressor, or a long or
•
smaller diameter air hose in relation to the nailing
frequency may cause a decrease in the driving
capability of the tool.
Lubrication
To insure maximum performance, install an air set
•
(oiler, regulator, air filter) as close as possible to the
tool. Adjust the oiler so that one drop of oil will be
provided for every 30 nails.
at
a
004295
When an air set is not used, oil the tool with
•
pneumatic tool oil by placing 2 (two) or 3 (three)
drops into the air fitting. This should be done before
and after use. For proper lubrication, the tool must
be fired a couple of times after pneumatic tool oil is
introduced.
5