Makita AN611 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita AN611. Makita AN611 13 сторінок. Construction coil nailer
Також для Makita AN611: Інструкція з експлуатації (19 сторінок), Розбивка на частини (4 сторінок), Розбивка на частини (4 сторінок), Інструкція з експлуатації (12 сторінок)

Друкувати сторінку

005237

FUNCTIONAL DESCRIPTION

Adjusting depth of nailing

CAUTION:

Always lock the trigger and disconnect the hose

•

before adjusting the depth of nailing.

To adjust the depth of nailing, turn the adjuster so

•

that the arrow above the adjuster will point to the

number indicated on the adjuster. The depth of

nailing is the deepest when the arrow points to the

number 1. It will become shallower as the arrow

points to higher number. The depth can be changed

in approx. 1.0 mm increments per graduation. If

nails cannot be driven deep enough even when the

arrow points to the number 1, increase the air

pressure. If nails are driven too deep even when the

arrow points to the number 9, decrease the air

pressure. Generally speaking, the tool service life

will be longer when the tool is used with lower air

pressure and the adjuster set to a lower number.

005240

ASSEMBLY

Loading nailer

CAUTION:

Always lock the trigger and disconnect the hose

•

before loading the nailer.

Select nails suitable for your work. Depress the

•

latch lever and open the door and magazine cap.

1. Pneumatic tool

oil

1. Adjuster

005241

Lift and turn the coil support plate to set it to the

•

correct step. When loading 57 or 65 mm long nails,

use the bottom step. When loading 45 or 50 mm

long nails, use the middle step. When loading 32 or

38 mm long nails, use the top step. If the tool is

operated with the coil support plate set to the wrong

step, poor nail feed or malfunction of the tool may

result.

005242

Place the nail coil over the coil support plate. Uncoil

•

enough nails to reach the feed claw. Place the first

nail in the driver channel and the second nail in the

feed claw. The nail heads must be in the slot in the

feeder body. Place other uncoiled nails on feeder

body. Close the magazine cap and door after

checking to see that the nail coil is set properly in

the magazine.

005243

Connecting air hose

Lock the trigger. Slip the air socket of the air hose

•

onto the air fitting on the nailer. Be sure that the air

socket locks firmly into position when installed onto

the air fitting. A hose coupling must be installed on

or near the tool in such a way that the pressure

reservoir will discharge at the time the air supply

coupling is disconnected.

1. Door

2. Latch lever

3. Magazine cap

1. Coil support

plate

1. Slot

2. Feeder body