Makita BJS161 Технічна інформація - Сторінка 7
Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita BJS161. Makita BJS161 9 сторінок. Cordless straight shears 1.6mm (16ga)
Також для Makita BJS161: Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (12 сторінок)
R
epair
[4] ADJUSTMENT
[4]-1. Side blades, Center blade
(1) Loosen M6x10 Hex socket set screw, as illustrated in Fig. 12.
Fig. 12
Loosen M6x10 Hex socket set screw
by turning with Hex wrench 3 approx.
360 degrees.
But, do not remove this screw.
(2) Adjust the gaps by inserting 1R366 into the gap A and B, and turning M4x25 Hex socket head bolt as illustrated
in Fig. 13.
Fig. 13
Gaps between Center blade and Side blades are defined depending on the thickness of the work piece.
Chose up two Thickness gauges from 1R366 for adjustment of the gaps referring to the following table.
Side blade L
A
Side
blade L
M4x25 Hex socket
head bolt
(on Side blade L side)
(3) After adjusting the gaps, tighten M6x10 Hex socket set screw with Hex wrench 3. Refer to Fig. 12.
Center blade
Side blade R
B
Side
blade R
Center blade
1R366
Thickness gauge
Thickness of
Required gap between
Work piece (mm)
A and B (mm)
less than 0.8
0.8 - less than 1.3
more than 1.3
Inserting the selected Thickness gauges into the gap A,
turn M4x25 Hex socket head bolt with Hex wrench 3
until the gap A can be adjusted to the required size.
In the same way, adjust the gap B. (almost same size to
Gap A)
Hex wrench 3
M6x10 Hex socket
set screw
(on Side blade R side)
Combination of
Thickness gauge
0.1
0.04 + 0.06
0.2
0.05 + 0.15
0.1 + 0.2
0.3
P 7/ 9