HIKVISION HiLook Series Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для ВІДЕОРЕЄСТРАТОР HIKVISION HiLook Series. HIKVISION HiLook Series 14 сторінок. Smart hybrid light bullet & turret camera
Також для HIKVISION HiLook Series: Посібник із швидкого старту (18 сторінок), Посібник користувача (18 сторінок), Посібник користувача (20 сторінок), Посібник користувача (18 сторінок), Посібник користувача (13 сторінок), Посібник користувача (17 сторінок)

Друкувати сторінку
HIKVISION HiLook Series Посібник користувача
Figure 1-2 Overview of Type II Camera
Note:
Press and hold the switch button for 5 seconds to
switch the video output. Four kinds of video outputs
are available: TVI, AHD, CVI, and CVBS.

2 Installation

Before you start
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the mount.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The ceiling mounting and wall mounting are similar.
Following steps take ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
4. Align the screw holes in the bracket to the ceiling,
and secure the camera with three PA4 × 25 screws
(supplied).
Figure 2-2 Secure the Camera to the Ceiling
5. Connect the cables.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
Scr ew H ol e
Figure 2-1 Drill Template
Scr ew H ol e
Scr ew H ol e
template