Gardena Classic 3500/4 Інструкція з експлуатації Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Водяний насос Gardena Classic 3500/4. Gardena Classic 3500/4 15 сторінок. Garden pump
Також для Gardena Classic 3500/4: Посібник оператора (10 сторінок), Посібник оператора (11 сторінок), Інструкція з експлуатації Посібник з експлуатації (14 сторінок), Інструкція з експлуатації Посібник з експлуатації (10 сторінок), Інструкція з експлуатації Посібник з експлуатації (7 сторінок), Посібник оператора (9 сторінок), Посібник оператора (10 сторінок)

Gardena Classic 3500/4 Інструкція з експлуатації Посібник з експлуатації
Pumping dirty water, e.g. stones, pine needles
etc., can cause damage to the pump.
v Do not pump dirty water.

3. Initial Operation

Setting up your Garden Pump:
Connecting hose to
suction side:
2
1
Connection hose to
delivery side:
5
4
3
z
The minimum flow rate is 90 l/h (= 1.5 l/min.).
Watering accessories with lower rate must not
be operated.
The site must be firm and solid in order to ensure safe and sturdy
operating conditions for the pump.
v Position the pump at a safe distance (min. 2 m) from the liquid
to be pumped.
The pump must be installed in a location with low air humidity
and sufficient ventilation in the area of the ventilation slots.
It must be at a distance of at least 5 cm from the walls.
No dirtcontamination (e.g. sand or earth) may be sucked in
through theventilation slots.
Don't use any hose connection system fittings on the
suction side! A vacuum-resistant suction hose must be used,
e. g. GARDENA Suction Unit, art. no. 1411.
In order to reduce the suction time, it is advisable to use a suction
hose with backflow preventer avoiding automatic draining of the
suction hose when the pump is stopped.
1. Screw a vacuum-resistant suction hose
connector on the suction side of the pump
2. For suction heights exceeding 4 m also secure the suction
hose
(e.g. by fastening it to a wooden post).
1
This relieves the pump of the weight of the suction hose.
The 3500/4 pump has 2 connections
The pump connection not in use has to be closed by the cap
which can be unscrewed for connecting 2 hoses.
The pump connections
thread which can be used to connect 13 mm (1/2"), 16 mm (5/8")
or 19 mm (3/4") hoses via the GARDENA hose connection system.
Optimised use of the pump capacity is achieved by connecting
19 mm (3/4") hoses with e.g. GARDENA Pump Connection Set
Art. 1752, or by connecting 25 mm (1") hoses with GARDENA
Quick Thread Coupling with female thread Art. 7109 / Quick
Coupling Hose Connector Art. 7103.
v Connect the pressure hose
side
/
.
3
ß
3a
If more than 2 (3000/4 more than 1) hoses / accessories are
connected simultaneously, we recommend using the
GARDENA 2- or 4-Channel Water Distributor Art. 8193/8194,
GARDENA Twin-Tap Connector Art. 940 which can be screwed
directly onto the connection on the delivery side
airtight onto the
1
2
/
on the delivery side.
3
ß
3a
/
are equipped with a 33.3 mm (G 1")
3
ß
3a
to the connector on the delivery
5
.
,
4
/
.
3
ß
3a
13