2,6Ah
ß
ß
ß
ß
ß
B
L1
L2
L3
W
4. Operation
Starting the blower:
0
Avoid exhaustive discharge:
If the battery is empty, the full discharge protection automatically
switches off the device to prevent the battery from discharging
fully. To prevent the fully charged battery from self-discharging
via the unplugged charger, it should be disconnected from the
charger after charging. If the battery was stored for more than
1 year, it must be fully recharged.
If the battery was fully discharged, the charging indicator lamp
will flash rapidly at the start of charging (twice per second).
If the charging indicator lamp
10 minutes, a fault has occurred (see 7. Troubleshooting).
ß
If the error-LED
on the battery flashes, a fault has occurred
W
(see 7. Troubleshooting). In case of a completely empty battery
it will take approx. 20 minutes until the LEDs on the battery
will indicate charging. But the charging process is indicated by
9
the flashing LED
on the charger.
Battery charging status indicator during operation:
ß
v Press button
on the battery.
B
66 – 99 % charged
L1, L2 and L3 lit.
33 – 65 % charged
L1 and L2 lit.
10 – 32 % charged
L1 lit.
1 – 9 % charged
L1 flashing.
0 % charged
No indicator.
DANGER! Risk of physical injury!
Do not use the unit without the tube properly
attached to avoid flying debris and/or impeller
contact which can cause serious injury.
v A lways wear gloves and use eye protection to
prevent rocks or debris from being blown or
ricocheting into the eyes and face which can
result in blindness or serious injury.
Switching the blower on:
1. Push the battery onto the handle
(see 3. Initial Operation).
2. Move the ON/OFF switch
Switching the blower off:
1. Move the ON/OFF switch
2. Remove the battery from the handle
(see 3. Initial Operation).
9
still flashes rapidly after
0
to the ON (I) position.
0
to the OFF (0) position.
9
19
Друкувати сторінку