AEG F88709M0P Посібник користувача - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина AEG F88709M0P. AEG F88709M0P 24 сторінки.

Друкувати сторінку

It is not necessary to remove the work-

top when installing under a standard

kitchen counter. Only remove the work-

top when installing the appliance under a

close fitting sink unit or kitchen counter

(820 mm).

Put the appliance adjacent to a water tap

and a water drain.

Make sure that the dimensions of the

recess agree with the dimensions in the

picture.

min 570 mm

820 mm

600 mm

Removing the work-top

1. Remove the rear screws (1).

2. Pull the work-top from behind (2).

3. Lift the work-top and move it from

the front slots (3/4).

4. Level the appliance using the

adjustable feet.

5. Install the appliance under the

kitchen counter.

Adjusting the level of the

appliance

A correct adjustment of the level of the

appliance allows the door to close and

seal correctly.

If the door does not close correctly,

loosen or tighten the adjustable feet to

level the appliance.

14.2 Water connection

Water inlet hose

Connect the inlet hose to a water tap

with an external BSP thread spout of

3/4''.

For best washing performance it is

recommended to connect the appliance

to a cold water supply.

Energy savings can be made by

connecting the appliance to a Solar

water system and using economy

options, however the water temperature

must not exceed 60° C.

Inlet water supply

• Water pressure: 800 kPa max - 50 kPa

min.

• Water flow rate 10 L / minute min.

• If water pressure is in excess of 800

kPa, a pressure reducing valve should

be used. Check for leaks.

• If water temperature is in excess of

60° C, a tempering valve should be

used. Check for leaks.

CAUTION!

Always use new hoses when

you connect the appliance

to the water mains. Old

hoses must not be used. The

water inlet hose must be

examined at an interval of

twelve months for

deterioration and replaced if

necessary.

The water pressure must be in the limits

indicated in the chapter ''TECHNICAL

ENGLISH