Brother RuggedJet RJ-4040 Посібник з програмного забезпечення - Сторінка 26

Переглянути онлайн або завантажити pdf Посібник з програмного забезпечення для Принтер Brother RuggedJet RJ-4040. Brother RuggedJet RJ-4040 48 сторінок. Multi-protocol on-board ethernet print server and wireless ethernet print server
Також для Brother RuggedJet RJ-4040: Короткий довідник (2 сторінок), Посібник користувача (33 сторінок), Короткий довідник (1 сторінок), Посібник користувача (34 сторінок), Посібник з безпеки продукції (22 сторінок)

Друкувати сторінку
Brother RuggedJet RJ-4040 Посібник з програмного забезпечення
(6) Phase type and phase number
If the phase number is not used, both are fixed at 00h.
Receiving state
Phase
Waiting to receive
Printing state
Phase
Printing
 When the printer is turned on, it is in the receiving state. When printing begins, it changes to the "printing"
phase (phase type: printing state; phase number: printing), and the printer sends that phase status to the
computer. When printing has finished, the printer sends the "receiving state" phase status (phase type:
receiving state; phase number: waiting to receive) to the computer. Unless an error occurs during printing,
the printer sends the "printing completed" status.
 With concurrent printing, printing starts even if a print command has not been sent from the computer in
order to print at high speed. At this time, care should be taken since the "printing" and "waiting to receive"
phase statuses will be sent. (Refer to
(7) Notification number
Cooling (started)
Cooling (finished)
(8) Battery level
Charging required
AC adaptor in use
Phase State
Receiving state
Printing state
Value (Dec.)
0
Value (Dec.)
0
"6. Flow
Notification
Not available
Battery Level
Full
Half
Low
Higher Order Bytes
00h
Higher Order Bytes
00h
Charts".)
- 22 -
Raster Command Reference
Phase Type
00h
01h
Lower Order Bytes
00h
Lower Order Bytes
00h
Value
00h
01h
02h
Value
00h
01h
02h
03h
04h
4. Printing Command Details