Fujitsu SDLT 160 GBYTE Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Зберігання Fujitsu SDLT 160 GBYTE. Fujitsu SDLT 160 GBYTE 15 сторінок.
Друкувати сторінку
SDLT 160/320 GBYTE
Installing the streamer
Please note the information provided in the operating manual of the computer or in the
!
"Safety and Ergonomics" booklet.
The following steps must be performed to install the streamer:
•
Setting jumpers
•
Mounting the streamer
•
Connecting the streamer
The drivers required for operating SCSI drives are either part of the operating system or
i
are provided with the software.
Setting jumpers
The drive can be set by means of jumpers. The jumpers can be found on the rear of the drive.
1 =
Connection for diagnostic purposes
2 =
Plug-in jumper for Wide SCSI
configuration
3 =
Plug-in jumper for Termination Power
Pin 1 is drawn bold in each case.
Connection for diagnostic purposes
This connection is only for internal use.
Wide SCSI configuration
With this plug-in jumper you can configure the streamer for Wide SCSI.
Pin pair 1/2 inserted = 8-bit SCSI
Pin pair 1/2 not inserted = 16-bit SCSI (Wide SCSI)
4 - English
1
2
5
3
4
Pin 1
4 =
Plug-in jumper for SCSI address
5 =
Connection for RS-422 (loader)
A26361-H814-Z100-1-7419