Brother Quattro 2 6700D Посібник з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Програмне забезпечення Brother Quattro 2 6700D. Brother Quattro 2 6700D 16 сторінок. Kit para crear efectos decorativos con bobinas
Також для Brother Quattro 2 6700D: Посібник з експлуатації (50 сторінок), Інструкція з експлуатації (40 сторінок), (Англійська) Інструкція з експлуатації (16 сторінок)

Leaving about 10 cm (approx. 4 inches) of

thread at the ends, use scissors to cut the

threads.

10 cm (approx. 4 inches)

Note

• Do not sew reinforcement/reverse stitches or use a

"Thread Cutter" button (if so equipped) at the end of

the stitching; otherwise it will be difficult to pull the

bobbin thread up to the wrong side of the fabric. In

addition the threads may become tangled or the

needle may break possibly causing machine

damage.

Finishing the thread ends

At the end of the stitching, pull the end of the

bobbin thread up to the wrong side of the

fabric.

Wrong side of fabric

Bobbin thread

Note

• If it is difficult to pull up the bobbin thread, use a

ribbon embroidery needle to pull the thread up to the

wrong side of the fabric. Otherwise, use an awl to

pull up the bobbin thread.

From the wrong side of the fabric, tie the

bobbin thread and the upper thread together

by hand, and then cut off excess threads with

scissors.

Wrong side of fabric

Surface of fabric

Note

• To ensure threads do not come undone after being

tied place a drop of fabric glue on knots.

If the desired results could not be achieved,

adjust the tension of the bobbin thread and of

the upper thread, and then try sewing the

stitching again.

For more details, refer to "ADJUSTING THE

THREAD TENSION" on page 13.