Kohler SV810-840 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler SV810-840. Kohler SV810-840 20 сторінок. Vertical crankshaft
Також для Kohler SV810-840: Посібник користувача (21 сторінок), Посібник користувача (21 сторінок)

Друкувати сторінку

Refer t otheoperating instructions o ftheequipment

thisengine powers. Because of equipment design or

application, theremaybemorestringent r estrictions

regarding theangleofoperation.

NOTE: Donot operate t hisengine continuously

atangles e xceeding 2 5 ° in anydirection.

Engine damage couldresult f rominsufficient

lubrication.

Cooling

NOTE:

If debris builds up on tile grass screen or other

cooling areas, stop the engine immediately

and clean. Operating

the engine with blocked

or dirty air intake and cooling areas can cause

extensive

damage due to overheating.

See

Clean Air Intake/Cooling

Area.

WARNING:

Hot Parts!

Engine components can get extremely hot from operation.

To prevent severe burns, do not touch these areas while

the engine is running, or immediately after it is turned

off Never operate the engine with heat shields or guards

removed.

Engine Speed

NOTE:

Do not tamper with the governor

setting

to increase

the maximum

engine speed.

Overspeed

is hazardous

and will void the

engine warranty.

Tile maximum

allowable

high idle speed for these engines is 3675 RPM,

no load.

Maintenance

instructions

Maintenance,

repair, or replacement

of the emission

control

devices and systems,

which are being done at the

customers

expense,

may be performed

by any non-road

engine

repair establishment

or individual.

Warranty

repairs

must be performed

by an authorized

Kohler service outlet.

WARNING: Accidental

Starts!

Disabling

engine.

Accidental

starting

can cause severe injury

or death. Before working

on the engine or

equipment,

disable the engine as follows: 1) Disconnect

the spark plug lead(s). 2) Disconnect

negative

(-) battery

cable from battery.

Maintenance

Schedule

These required

maintenance

procedures

should be performed

at the frequency

stated in tile table. They should

also be included

as part of any seasonal

tune-up.

Frequency

Maintenance

Required

Fill fuel tank.

Daily Or Before

•

Check oillevel.

Starting Engine

•

Check air cleaner for dirty _,loose, or damaged

parts.

Check air intake and cooling areas, clean as necessaryL

Every 25 Hours

Service precleaner

elementL

Every 50 Hours

Check air cleaner element,

clean or replace as necessary _.

Replace air cleaner element

and precteanerL

Change

oil and oil filter (more frequently

under severe conditions).

Annually

Remove cooling shrouds

and clean cooling areas _.

Every 100 Hours

Replace fuel filter.

Check spark plug condition

and gap.

Every 200 Hours

Have valve lash checked/adjusted

Have bendix starter drive serviced 2.

Every 500 Hours

Have solenoid

shift starter disassembled

and cleaned 2.

_Perform

these maintenance

procedures

more fl_equently

under

extremely

dusty,

dirty conditions.

2Have a Kohler

Engine

Service

Dealer perform

these services.

Check Oil Level

The importance

of checking and maintaining

the proper

oil level in the crankcase

cannot be

overemphasized.

Check oil BEFORE EACH USE as

follows:

Make sure the engine is stopped,

level, and is cool

so the oil has had time to drain into the sump.

Clean the area around

and the underside

of the

oil fill cap/dipstick

before removing

it. This will

help keep dirt, debris, and other foreign matter

out of the engine.