Aqua Computer Aquaduct 360 eco Посібник з експлуатації та монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з експлуатації та монтажу для Комп'ютерне обладнання Aqua Computer Aquaduct 360 eco. Aqua Computer Aquaduct 360 eco 20 сторінок. Aquaduct eco series

Друкувати сторінку

AQUADUCT ECO

by hand. The screw should now be fixed to the board like a standing

bolt. Do the same with the three other screws. Now the cuplex can care-

fully and slowly be put onto the standing bolts. Slowly slide it down until

it rests on the prepared core of the processor, without getting it stuck.

To protect the acrylic glass of the cuplex from getting scratched slide an-

other washer over each screw. Now put one of the supplied springs over

each of the standing bolts.

extent, that a slight but visible slit is left between

the coils. You can check this by sliding a piece

of paper between the coils, as illustrated on the

photo. If this is not possible, you fastened the

knurled bolts too much and you have to loosen

them. Also make sure that the cuplex does not

rest on the cover of the barring mechanism of

the socket, but on the core of the processor.

6.3. Installation of „2-hole-mounting kits" - Socket 754, 939, F

Should be more than two feathers included in the screw set, please use

the two „harder" feathers.

For the installation on Athlon64 boards the cooler is put together in

analogy to the four-hole-mounting kit but this time only two screws will

be used here since only two fastening holes are available on the board.

Before the assembly of the screws an existent plastic framework must be

removed if necessary. The two bigger feathers of the mounting kit are

used as feathers. Please gather the further procedure from chapter 6.3.

- 12 -

Screw one of the supplied knurled nuts on

each screw about 2 turns, so it just grips.

For fastening the springs, take turns in

fastening two knurled nuts at a time

placed opposite of each other diagonally.

During this process make sure that the

spring coils do not touch each other, since

spring coils do not touch each other

this can cause inadmissible high forces to

build up. The spring has to

be fastened to the

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen