Aqua Computer Aquaduct 360 eco Руководство по эксплуатации и сборке - Страница 12

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и сборке для Компьютерное оборудование Aqua Computer Aquaduct 360 eco. Aqua Computer Aquaduct 360 eco 20 страниц. Aquaduct eco series

AQUADUCT ECO
by hand. The screw should now be fixed to the board like a standing
bolt. Do the same with the three other screws. Now the cuplex can care-
fully and slowly be put onto the standing bolts. Slowly slide it down until
it rests on the prepared core of the processor, without getting it stuck.
To protect the acrylic glass of the cuplex from getting scratched slide an-
other washer over each screw. Now put one of the supplied springs over
each of the standing bolts.
extent, that a slight but visible slit is left between
the coils. You can check this by sliding a piece
of paper between the coils, as illustrated on the
photo. If this is not possible, you fastened the
knurled bolts too much and you have to loosen
them. Also make sure that the cuplex does not
rest on the cover of the barring mechanism of
the socket, but on the core of the processor.
6.3. Installation of „2-hole-mounting kits" - Socket 754, 939, F
6.3. Installation of „2-hole-mounting kits" - Socket 754, 939, F
6.3. Installation of „2-hole-mounting kits" - Socket 754, 939, F
6.3. Installation of „2-hole-mounting kits" - Socket 754, 939, F
Should be more than two feathers included in the screw set, please use
the two „harder" feathers.
For the installation on Athlon64 boards the cooler is put together in
analogy to the four-hole-mounting kit but this time only two screws will
be used here since only two fastening holes are available on the board.
Before the assembly of the screws an existent plastic framework must be
removed if necessary. The two bigger feathers of the mounting kit are
used as feathers. Please gather the further procedure from chapter 6.3.
- 12 -
Screw one of the supplied knurled nuts on
each screw about 2 turns, so it just grips.
For fastening the springs, take turns in
fastening two knurled nuts at a time
placed opposite of each other diagonally.
During this process make sure that the
spring coils do not touch each other, since
spring coils do not touch each other
spring coils do not touch each other
spring coils do not touch each other
this can cause inadmissible high forces to
build up. The spring has to
be fastened to the
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
© 2007-2016