Aqua Flo AQUV-12R2 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Системи фільтрації води Aqua Flo AQUV-12R2. Aqua Flo AQUV-12R2 16 сторінок. Ultraviolet disinfection system

Друкувати сторінку

Spring

8. From the top of the gland nut, drop the lamp spring into the quartz dome

Fig. 6C.

9. Holding the top 4-pin end of the lamp, carefully slide the lamp into the

quartz dome and attach the lamp pins to the lamp connector. The lamp

connector fits over the pins in only one orientation Fig. 6D.

10. Slide the lamp connector cover over the gland nut and tighten the black

screw on it Fig. 6E. Check tightening details, the black screw allows the cord to come through the plastic making it easy to hook up lamp, then

white plastic part has a little screw to secure it to the gland nut.

11. Remove the nut from the ground stud at the top of the unit. Next place the ground wire (green wire with yellow stripes) over the stud and

tighten the nut.

12. Connect the ballast power cable to the AC supply (with surge protector). The green lamp-on LED will light up and the display will show "365".

This number indicates the number of days left until lamp life expires and must be replaced. Follow Step (E) before consuming water.

YOUR AQUA FLO AQUV UV DISINFECTION SYSTEM IS NOW READY FOR SERVICE.

(E) DISINFECTION PROCEDURE

Before service begins, all household plumbing lines should be disinfected to prevent the possibility of re-contamination after UV disinfection. You

should also disinfect your plumbing system if the power goes out for several hours or more or if the unit has been accidentally shut-off for several

hours or more. It is advisable to disinfect the plumbing lines at least once a year. If the bypass is used, the water system of the house should be

disinfected in the same way it was in initial installation. Disinfect after using bypass as well.

The following is a general method for disinfection of plumbing lines. If you are uncertain about the

efficacy of this procedure you are advised to contact your local health authority responsible for water

safety.

1. Shut off the supply valve and de-pressurize the lines by opening a tap until it runs dry.

2. Remove the filter in the filter housing, add about 1-2 cups (250-500ml) of unscented household bleach (5 to 6% sodium hypochlorite) to the

empty filter housing and put it back on the filter head.

3. Open the supply valve and slowly open a faucet and let the water run until you can smell the chlorine and then shut the faucet off. Repeat the

procedure for all hot and cold outlets in the house. Add more bleach as required. Run hot faucets longer to allow the chlorine to come through

the hot water tank.

4. Leave the bleach solution in the plumbing system for about 6 to 8 hours preferably overnight.

Fig.6C

Lamp

Fig.6D

WARNING

Installing lamp without the spring in place can cause

breakage of quartz dome.

Fig.6E